Welcome to Our selection of Alarm Speaker 8 ohm, Alarm Speaker 8 ohm, Electronic Sounder Pulsed, 3 - 16 VDC, Electronic Sounder Pulsed, 3 - 16 VDC, Electronic Sounder Steady, 3 - 16 VDC Electronic 1K Hertz Tone, Photo Beam Entrance Alert, Add on Speaker unit for EA2 Photo Beam Alert System, Wireless Motion Detector


Alarm Speaker 8 ohm - 746
Alarm Speaker 8 ohm


Alarm Speaker 8 ohm
Specs:
8 Ohm 15watt
White Finish

Price is $16.99
Free Shipping All Orders



Electronic Sounder Pulsed, 3 - 16 VDC - EC2
Electronic Sounder Pulsed, 3 - 16 VDC


Electronic Sounder Pulsed, 3 - 16 VDC
Black Casing with Pins for connection. You can solder to a PC Board or solder on Pigtails depending on your application.
Audible piezo alarm emits a Pulsed, high-pitched tone of low to medium loudness. Operates on 3-16 Vdc. Rated at 12 Vdc. 4000 Hz @ 12 Vdc, 7 mA. 80 dBA/ 10 cm. 0.54" diameter x 0.3" high. Connections made with a red and white pigtailed leads.

Price is $8.99
Free Shipping All Orders



Electronic Sounder Steady, 3 - 16 VDC Electronic 1K Hertz Tone - EC3
Electronic Sounder Steady, 3 - 16 VDC Electronic 1K Hertz Tone


Electronic Sounder Steady, 3 - 16 VDC Electronic 1K Hertz Tone
Audible piezo alarm emits a solid, high-pitched tone of low to medium loudness. Operates on 3-16 Vdc. Rated at 12 Vdc. 4000 Hz @ 12 Vdc, 7 mA. 80 dBA/ 10 cm. 0.54" diameter x 0.3" high. PC leads on 0.25" centers.

Price is $8.99
Free Shipping All Orders



Photo Beam Entrance Alert - EA2
Photo Beam Entrance Alert - Break Beam Door Entry Alarm
Complete Hardwired System
* Uses Invisible Beam of Light
* Settings for Alarm or Chime
* Volume Control
* Power Supply included
* Plugs in to Standard AC Outlet
* Works with Door Open or Closed


Photo Beam Entrance Alert
Retro-reflective design.
Perfect for monitoring an entrance or use as an entrance indicator.
Will make “ding-dong" sound or siren sound when the beam is interrupted.
Speaker volume can be adjusted or turned off.
When in siren mode, sounding time is adjustable from 3 to 30 seconds.
9VDC adapter included.
All components plug into each other. No hard wiring required.
Includes the following:
NIR retro-reflective sensor.
Reflector.
Speaker.
9VDC 200mA output adapter.
Model Number E-931CS22RRC
Type NIR Retro-Reflective Entry Alert System
Sensing Range 22' (7 m)
Supply Voltage Sensor: 9-15 VDC, Chime: 12VDC
Total Current Drain 100mA Max.
Standby Current 25mA Max.
Light Source: IR LED
Control Output: Relay (AC 120V/DC 24V, 2A)
Ambient Temperature: -4ºF (-4º-20ºC) ~ 122ºF (50ºC)
Speaker Response Time: ~1 sec. for Chime, 30 sec. for Alarm
Speaker Volume Adjustable from 0 ~ max.
Alarm Time Range: Adjustable 3~30sec. for alarm
External Chime Output: Ground output (100mA)
Speaker Output: Chime / Off /Alarm (Select by switch)
Mounting Brackets: All Included

Price is $145.99
Free Shipping All Orders



Add on Speaker unit for EA2 Photo Beam Alert System - EA2S
Add on Speaker unit for EA2 Photo Beam Alert System
Features a 30 Foot Cable that plugs into The EA2 Photo Beam Entry Alert. Adds a second chime.


Speaker:
Additional speaker / electronic chime.
Use any standard stereo cord with 1/8" stereo plug

Price is $39.99
Free Shipping All Orders



Wireless Motion Detector - HS4340D
Wireless Motion Detector, Home Security Alarm
Enclosed you will find:
• Wireless motion detector
• Mounting bracket
• Magnetic contacts
• Remote control
• Two 1.5 volt batteries (installed)
• Wall anchors
• Screws
Tools and Supplies Needed:
• Small flat headed screwdriver
• Small Phillips head screwdriver
• Ballpoint pen
• 7/32” drill bit
Batteries Needed (not included):
-Three alkaline “AA” batteries


Wireless Motion Detector, Home Security Alarm with Key Chain Remote
The wireless motion detector can be used as a portable alarm or can be wall mounted where the adjustable PIR (passive infrared) sensor will detect movement over an area of 30 feet by 110 degrees. It can be alarmed/disarmed with the enclosed infrared remote control unit. The chime feature can be used to announce visitors at the home or office.

OPERATION
Remove the back of the unit by unscrewing the screw located at the top of the locked battery compartment and slide down. Insert three AA alkaline batteries (not included) into the compartment located in the back of the unit. Alternatively, a 7.5-15 volt adapter (not included) can be connected to the jack socket located at the side of the unit. The unit is also equipped with terminals for use with the magnetic contacts.

Batteries are included in your remote control. When batteries run low, replace them with two 1.5 volt type button cell batteries. Simply open remote control by removing screws and replace batteries.

Price is $52.99
Free Shipping All Orders


Shopping Cart
Review Your Cart
Checkout
 
Legal
Upon Purchase You are stating You are 18 or older. Also that use of product is for legal purposes. No Sales to Minors!!! It is up to the Consumer to establish the Laws in their Area.
 
Shipping
Shipping is included in the price No Hidden Charges! The Price you see is Delivered to your Door. We ship only to US Destinations. Included Shipping is USPS Priority.
 
Payment
We accept: MasterCard, Visa, Discover, American Express.  All Orders are processed by a SECURE SERVER!  Mail Orders using Money Orders and Cashiers Check are also welcome. We will also process a personal check, but will not ship till  check has cleared the Bank..
 
Home Page
Click for Home
 
Company Info
At NWC we have been serving customers since 1993, Our staff is knowledgeable about electronics and  Electronic Pest Repellers. We have 25 Years Experience in the Electronics Industry.
 
Contact us
Click to Email

© Copyright 1993 - 2010
www.PestControls.us
All Rights Reserved!

20074